Written by Admin and published on https://www.familyhandyman.com/
A stump grinder chews away at the stump wood that’s left after a tree has been cut down. All stump grinders use a powerful, rotating blade that rips into the wood as it turns. The blade’s teeth cut the stump wood into small pieces. The operator guides the blade over the entire stump as the blade reduces the wood to chips, and takes the stump down to well below ground level.
Stump grinding results in lots of chips of wood. You’ll make more of them than you think, but they can be used as mulch on-site or added to your green waste can. You’ll also have a hole, since you’ve just ground out all the stump volume that filled it. You can shovel the wood chips into the hole to decay, or you can import soil and fill the hole so that it’s even with the surrounding ground.
How to Remove a Tree Stump with a Grinder
Learn how to remove a tree stump yourself using a grinder.
Q: I have three oak stumps in my yard, the largest of which is 20 in. across. I noticed my rental store has a portable stump grinder. Is it worth renting it to remove my stumps? — S. Underberg, Raleigh, NC
A: Yes, but it requires a strong back. The minimum half-day charge for a basic rental grinder is about $50. In contrast, for your three stumps, a pro might charge $110, at a rate of $2 per inch of stump width. All this means you’ll save 60 bucks, get some exercise, and have fun using a cool tool.
Even so, a pro might be a better option for those who have more than five or six good-sized stumps to remove. That’s because the pros use hydraulic equipment that grinds large stumps much faster than a rental grinder can. So it might cost less to hire the pro than to rent the grinder. To get an estimate, call a professional listed in the Yellow Pages under “Tree Service.” You can often save up to 50 percent of a professional’s fee by cleaning up the chips yourself.
Project step-by-step (4)
Round up your hearing and eye protection; you’ll need it when you run the grinder. Wear heavy-duty work clothes, like a long-sleeved shirt, gloves, pants and work boots.
Dig a furrow around the stump. This furrow not only provides a place to collect the chips, it makes it possible to remove troublesome rocks. Running the grinder head into a rock can ruin the teeth, costing you about $15 per tooth to replace.
How Deep to Grind
Before starting, call your gas and electric company to have them locate underground lines. The stump you’re removing might have grown on top of them. If you plan to build on or pave the spot, remove the stump to a depth equal to its diameter. That way it won’t have much wood mass left in the ground to rot and settle. Otherwise, grind the stump to a depth of 6 to 10 in. below grade.
Position the Machine
Remove the tow bar and roll the grinder up to the stump. Adjust the handlebars so they’re at a comfortable working height—about waist height.
Set the brake. Push down on the handle-bars to raise the cutter head free of obstructions and start the engine. It’s a little tricky to hold the handlebars down and start the engine at the same time, so you may need a helper. Throttle the engine to full open.
Let the weight of the machine apply the force to the cutting head. Don’t pull up on the handlebars to grind faster.
Pivot the grinding head slowly across the stump by rolling the unlocked wheel forward and back. Shut the engine off after removing about 4 to 6 in. of stump, then roll the machine forward, reset the brake and resume grinding. It usually takes about 45 minutes to grind a 20-in. oak stump. Check out another way to remove a tree stump yourself.
Original post here https://www.familyhandyman.com/project/how-to-remove-a-tree-stump-with-a-grinder/.